騎時_ AI智慧型腳踏車升降椅墊

Rise N Ride _ AI Smart Bike Seat Height Adjustment Cushion"

經過我們觀察發現,一般民眾在騎乘單車時比起慢性傷害像是膝蓋彎曲幅度過大、駝背,更在意像是挫傷、摔傷等這種立即的傷害,所以會為了避免受傷,而將椅墊調整至不正確的高度,因而導致錯誤的騎乘姿勢。
正確的騎乘姿必須將椅墊調高自踏板踩到最低點時,腿能微彎 (大約小於30度) 或伸直。
這樣可以避免腿部肌肉無法完全伸展,膝蓋彎曲幅度過大導致力量壓迫在膝蓋而造成疼痛,且能減少腰部壓力造成的慢性傷害,但最為正確的騎乘姿勢需將椅墊升高至一定高度,必定有相對的危險性。
此款智慧型升降椅墊利用電動升降桿和自動/手動感應器做結合,當踏板感應到單腳壓力即自動上升,反之雙腳壓力消失下降讓您在發生危險時能自動下降椅墊,既減少傷害也保障安全,也可以手動方式自行決定下降/上升時機,讓您在都市騎乘中能達到長久穩定且舒適的騎乘。

Rise N Ride _ AI Smart Bike Seat Height Adjustment Cushion"

Through our observation, we have found that the general public, when riding bicycles, is more concerned about immediate injuries such as abrasions and falls, rather than chronic injuries such as excessive knee flexion and hunchback posture. Therefore, in order to avoid injury, they often adjust the seat cushion to an incorrect height, resulting in an improper riding posture.

The correct riding posture requires adjusting the seat cushion so that when the pedal is at its lowest point, the legs are slightly bent (approximately less than 30 degrees) or fully extended. This can prevent the leg muscles from being unable to fully stretch, reduce the pressure on the knees caused by excessive knee flexion, and also alleviate chronic injuries caused by pressure on the lower back. However, achieving the most correct riding posture by raising the seat cushion to a certain height inevitably comes with relative risks.

This intelligent adjustable seat cushion utilizes electric lifting rods and automatic/manual sensors. When the pedal senses pressure from a single foot, it automatically rises; conversely, when pressure from both feet is released, it descends. This allows the seat cushion to automatically lower when danger is detected, reducing injuries and ensuring safety. Additionally, it can be manually adjusted to descend or ascend according to the rider's preference. This enables riders to achieve long-term stability and comfort during urban cycling.

 
作品編號 #626 作品名稱 騎時_ AI智慧型腳踏車升降椅墊 作品分類 立體造型暨產品設計類工業設計組 學校科系 義守大學 創意整合設計學系 設計師 歐晴華
義守大學 創意整合設計學系
(四年級)

陳奕匡
義守大學 創意整合設計學系
(四年級)

陳姵蓁
義守大
(四年級)
指導老師 林永峻